Main »

Ultrasonic bracket

Started 20th September 2018
A bracket to hold ultrasonic sensors (like the HC-SR04) on the X axis rails of my HEVO printer - it will probably fit my ebay printer too. The idea is to use the Z axis motion to benchmark the distance output from the sensors. The bracket also supports a 50 x 70 mm piece of protoboard which can contain an Arduino Pro Mini to control the sensor.

3D printer ultrasonic bracket, David Pilling3D printer ultrasonic bracket, David Pilling

The photos show transducers separated from a HC-SR04 but the entire sensor will also fit.

3D printer ultrasonic bracket, David Pilling3D printer ultrasonic bracket, David Pilling3D printer ultrasonic bracket, David Pilling3D printer ultrasonic bracket, David Pilling3D printer ultrasonic bracket, David Pilling

Downloads:

Comments
*Click to email a comment

Click to return to index

David Pilling's Wiki

Set view

Page last modified on September 22, 2018, at 12:57 AM - Powered by PmWiki pmwiki-2.3.31 (pmwiki-2.3.31)

^